U.S. Cargo Vessel Anchoring: 46 CFR 96.07 Reference

● 2026-11-19 ● - ● Leave me a message

For vessels already confirmed subject to 46 CFR Subchapter I, the anchoring route turns on the date the vessel was contracted for.[1] Use the first table to identify the route before consulting the service and equipment alternatives. This reference is based on the annual edition revised October 1, 2025, checked on November 17, 2026; it does not determine project applicability or reproduce ABS equipment tables. For procurement preparation, retain the applicable route, service and supporting project records together rather than treating a table row as a standalone equipment specification.

Contract-date route

Scope: Already-confirmed Subchapter I vessels; contract date, not construction date.

Row ID Object Condition Requirement Notes Source
D52 Vessels within the confirmed Subchapter I scope Contracted for on or after November 19, 1952 Apply this subpart except §96.07-90. 46 CFR (2025) — §96.07-1(a)
D51 Vessels within the confirmed Subchapter I scope Contracted for before November 19, 1952 Apply §96.07-90: previously accepted or approved installations remain satisfactory for the same service while maintained in good condition to the satisfaction of the Officer in Charge, Marine Inspection (OCMI). If service changes, the OCMI establishes equipment suitability. 46 CFR (2025) — §96.07-1(a); 46 CFR (2025) — §96.07-90(a)(1)

Service and equipment requirements

Scope: Use after the date-route table; §§96.07-5 and 96.07-10.

Row ID Object Condition Requirement Notes Source
SEA Vessels except unmanned barges Ocean, coastwise or Great Lakes service Fit anchors, chains and hawsers in general agreement with ABS standards; ABS anchor-equipment rules are mandatory, not a guide. SCOPE, MAND 46 CFR (2025) — §96.07-5(a); 46 CFR (2025) — §96.07-5(b)(1)
S1 Vessels using the small-vessel alternative Within §96.07-5: length under 200 feet (61 meters) AND ABS equipment number less than 150 Alternative: one anchor of the tabular weight and one-half the tabulated anchor-chain length in the applicable standard. SCOPE, SMALL 46 CFR (2025) — §96.07-5(b)(2); 46 CFR (2025) — §96.07-5(b)(2)(i)
S2 Vessels using the small-vessel alternative Within §96.07-5: length under 200 feet (61 meters) AND ABS equipment number less than 150 Alternative: two anchors each of one-half the tabular weight with the total tabulated anchor-chain length; both anchors ready for use at all times AND the windlass capable of heaving in either anchor. SCOPE, SMALL 46 CFR (2025) — §96.07-5(b)(2); 46 CFR (2025) — §96.07-5(b)(2)(ii)
TUG Tugs Within §96.07-5: length under 200 feet (61 meters) At least one anchor of one-half the tabular weight in the applicable standards; no equipment-number threshold is stated in this paragraph. SCOPE 46 CFR (2025) — §96.07-5(c)
CLS Vessels using other recognized classification-society standards Within §96.07-5; approval by the Commandant Other recognized classification-society standards may be used instead of ABS standards upon that approval. SCOPE 46 CFR (2025) — §96.07-5(d)
INL Vessels in lakes, bays and sounds, or river service Vessel size and operating waters considered Fit ground tackle and hawsers deemed necessary by the OCMI. SCOPE 46 CFR (2025) — §96.07-10(a)

SCOPE: Apply the contract-date route before the service/equipment table; do not replace the pre-1952 route. — 46 CFR (2025) — §96.07-1(a)

MAND: ABS anchor-equipment rules under §96.07-5 are mandatory, not guidance. — 46 CFR (2025) — §96.07-5(b)(1)

SMALL: Length under 200 feet (61 meters) AND ABS equipment number less than 150 are both required. The two equipment arrangements are alternatives. — 46 CFR (2025) — §96.07-5(b)(2)

How to read the alternatives

Within §96.07-5, the small-vessel alternatives require both a length under 200 feet and an ABS equipment number below 150.[1] One alternative uses one anchor of the tabular weight and half the tabulated chain length in the applicable standard.[1] The other uses two anchors, each of half the tabular weight, with the total tabulated chain length, provided both are ready for use at all times and the windlass can heave either anchor.[1] For procurement preparation, consult the applicable standard for the tabular values; this reference does not supply those values.

Avoid these misreadings

The separate tug provision specifies tugs under 200 feet and states no equipment-number threshold.[1] For lakes, bays and sounds or river service, the OCMI determines the necessary ground tackle and hawsers with regard to vessel size and operating waters.[1] Do not treat the inland-service row as an equipment exemption or assume that the tug provision applies to every tug.

Prepare an anchor-and-chain enquiry

For procurement preparation, assemble the vessel’s contract date, service, dimensions, equipment number where relevant, applicable standard and available equipment records. Review the project’s required arrangement before discussing marine anchors and anchor chain, and share the relevant details through the contact page. Confirm project applicability and the required technical review with the responsible authority and project team.

Sources

[1] https://www.govinfo.gov/content/pkg/CFR-2025-title46-vol4/xml/CFR-2025-title46-vol4-part96.xml — 46 CFR Part 96, Subpart 96.07 — Anchors, Chains, and Hawsers

Send Inquiry

X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy